Vitek VT-3952 User Manual download pdf (Page 5)



service center.

2. Disconnect power cord from wall outlet to

switch the appliance off completely.



. Disconnect player from mains supply.

2. Open battery compartment cover (2)

located at its back by pressing the latch in

direction indicated by arrow.

. Insert eight batteries of UM-2/R / C type

(not included into delivery set) in battery

compartment following the polarity.

. Close battery compartment cover (2).

Notice: If quality od the appliance operation is

deteriorating, check the batteries and replace

them if necessary.



Use only batteries of recommended type.

Do not expose them to direct sunlight and heat

sources.

Battery leakage could cause injury or damage

the appliance. Follow the instructions below in

order to avoid it:

- Install batteries properly, following the

polarity and in accordance with marks on

the appliance.

- Do not use batteries of different types

together (old and new ones, batteries of

different types, etc.)

- Take batteries out if you are not going to use

the appliance for a long time



Use slot AUX IN for connecting auxiliary device.

Set operating modes switch (6) to position

«AUX»

Connect headphones slot of auxiliary device

with AUX IN slot located at the back of your

player using ,5 mm Jack - ,5 mm Jack audio

cable (not included into delivery set).

Switch on auxiliary device. Now you can listen to

recordings through speakers of your player.



Connect headphones (not included into delivery

set) to Phones slot for listening music via

headphones. Adjust necessary volume level

using VOLUME knob. Player’s speakers are

switched off automatically when headphones

are connected.

Attention! Do turn on too loud a sound while

listening via headphones. Physicians do

not recommend continuous listening via

headphones.



Set switch Bass Boost to «ON».position to

enhance bass.

Set switch Bass Boost to « OFF ».position to turn

off bass booster.



Always set operating mode switch to OFF

position if you do not use the appliance for

electricity saving purposes.



. Set operating mode switch to RADIO

position.

2. Select band: FM, AM or FM ST (FM stereo)

by setting operating mode switch to

corresponding position.

. Select and tune the station you need by

rotating station tuning knob TUNING.

While tuning to station transmitting stereo

signal, indicator FM ST is on. If stereo signal

from FM station is weak, try setting band

switch to FM position.

. Pull antenna completely out and direct it

properly to improve reception in FM band.

Player is equipped with built-in antenna

for AM reception. Try several locations of

player.

5. Set operating mode switch to OFF or

select another position upon completion of

listening to radio.





Always close disk compartment cover to prevent

it from dust.

Always take disc out if you are not going to play

it back.

Do note open disk compartment cover during

playback.

If player jumps from track to track during

playback, reduce volume.

Set operating mode switch to OFF position when

you do not need CD player.

. Select CD playback mode by setting

operating mode switch to CD position.

2. Open disk compartment cover. Insert disc

in and close the cover. Make sure disc is

inserted properly, label up. Total number of

3952IM.indd 5 20.06.2008 11:40:01

1 2 3 4 5 6 7 8 9 10 ... 47 48

Comments to this Manuals

No comments

Vitek VT-3952 User Manual Page 5

Comments to this Manuals

Related products and manuals for Car radio Vitek VT-3952