Vitek VT-1370 B User Manual download pdf (Page 5)

5

RECHARGEABLE SHAVER

DESCRIPTION

1. Protective cap

2. Shaver block

3. Rotating blades

4. Blade drive

5. Shaver block locking button

6. Shaver housing

7. Power switch with locking button

8. Charging indicator

9. Charger

10. Cleaning brush

11. Travel bag

Charging (Fig.1)

Before using the shaver for the first

time or after a long period of disuse, it

should be charged for 6 hours.

- Insert the charger plug (9) into the

charging socket on the bottom side

of the housing and connect the

charger to the electrical network;

the charging indicator (8) will light.

- Supplemental charging cycles of

the rechargeable battery should

not exceed two hours.

Attention!

- Do not charge the rechargeable

batter for more than 10 hours or

in temperatures lower than 0°C or

higher than 40°C, as this can cause

damage.

- If the shaver is not used for more

than 20 days, then it should be

charged for six hours.

Using the shaver

The best shaving results are achieved

if your skin is dry.

Your skin may need 2-3 weeks to

adapt to this shaving system.

- Remove the protective cap (1).

- Turn on the switch (7).

- Lightly touch the skin, moving

around the shaving block using

simultaneous up-down and rotat-

ing motions.

- Turn off the shaver with the power

switch (7), cover the shaving block

with the protective cap (1) and

store the shaver.

Using the trimmer (Pic. 2, 3)

The trimmer is designed for evening

whiskers and caring for mustaches.

- Move the trimmer switch to the

upper position.

- Turn on the shaver with the switch

(7).

- Position the shaver at the correct

angle to the skin and move it gradu-

ally down, evening the whiskers.

- Turn off the shaver and move the

trimmer switch to the lower posi-

tion.

Cleaning the shaver

- Press the shaving block locking but-

ton (5) to open the shaving block

and gain access for cleaning (Pic.

4).

- Using the brush (10), clean the

shaving block inside and out, and

also the blade drive (Pic. 5).

- The shaving block can be washed

under a stream of warm water (Pic.

6). Dry the shaving block com-

pletely before closing. Do not allow

water into the electric shaver's

body. After completely dry, close

ENGLISH

1370.indd 51370.indd 5 28.02.2006 10:35:3328.02.2006 10:35:33

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comments to this Manuals

No comments