Vitek VT-1351 User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
РУССКИЙ
3. Держите машинку для стрижки волос таким
образом, чтобы она располагалась удобно в
вашей руке, и слегка прижимайте ее к голове
(при этом зубья расчески должны быть
направлены вверх). Постепенно и медленно
перемещайте машинку по направлению вверх и
наружу, срезая каждый раз совсем небольшое
количество волос.
4. По мере проведения стрижки поднимайте
головку машинки по направлению к себе.
Продолжайте стричь затылок в направлении от
основания шеи к ушам.
ОПЕРАЦИЯ 2  ЗАТЫЛОК
Смените приспособление для расчесывания волос
на размер 9 или 12 мм и сделайте стрижку затылка
(рис. 2).
ОПЕРАЦИЯ 3  СТРИЖКА СБОКУ
Перейдите на расческу размером 3 или 6 мм и
подстригите баки, т. е. волосы, растущие
непосредственно перед ушами на висках. Затем
перейдите на расческу размером 9 мм или 12 мм и
продолжайте стричь волосы по направлению к
макушке ( рис. 3).
19
ENGLISH
the blades lightly touching the skin and work down
wards. This way you will obtain, as a clean cut as
would be given by a razor.
SHORT TAPERED STYLES 'FLAT TOPS' AND
SHORT CUTS
1. Starting with the longest attachment comb (12mm
), cut from the back of the neck to the crown. Hold
the attachment comb flat against the head and
slowly move the clipper through the hair, as shown
(see diagram 8).
2. Use the same procedure from the. lower side to the
upper side of the head, as illustrated. Then cut the
hair against the direction in which it grows from the
front to the crown and then level the cut with the
sides.
3. To give a 'flat top' look, the hair on top of the head
must be cut over the top of a flat comb rather than
by using the attachment comb.
4. Use closer cutting attachment combs to taper the
hair down to the neckline as desired. Comb hair
and check for uneven areas and outlining side
boards and neckline as described previously.
SERVICE LIFE OF THE HAIRCUTTING SET
NOT LESS THAN 3 YEARS
10
Рисунок 2
Рисунок 3
Diagram 7 Diagram 8
1351new.qxd 22.10.02 17:55 Page 20
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments